Downloads

Related Links

Related Stories

News

An introduction to RTM for aerospace composites

The National Aerospace Laboratory (NLR) in the Netherlands is organising a training course covering the use of the resin transfer moulding (RTM) process in manufacturing composite aerospace components.

Introduction To Resin Transfer Moulding is being held on 24-26 April 2012 at the NLR Flevoland site, which is just over 1 hour by car from Amsterdam airport.

The course has a high practical content. Participants will spend time in the laboratory, where they will manufacture preforms using different techniques, carry out permeability experiments to visualise flow fronts, and manufacture flat plates with different RTM techniques.

The course is appropriate for designers, engineers and managers with little or no experience of RTM.

The course will be given in English and limited to 12 delegates.

For more information and a registration form, contact Ineke van Wijk at NLR.

 

 

Share this article

More services

 

This article is featured in:
Processing technology

 

Comment on this article

You must be registered and logged in to leave a comment about this article.